Getting The Best Swim Spa Cover

Swim Spas represent special challenges when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub requires a cover. The difficulty is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot harder.
Getting a new swim spa is an exciting occasion in life. You’re anticipating the exercise you’ll get from using it. Possibly you’re a little relieved to have actually lastly selected from the different models you took a look at. At any rate, you probably weren’t believing much about the cover you would use.
Normally, the cover that gets home with your brand-new purchase will be a 4 area stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence due to the fact that as quickly as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are really small as they increase from the water surface. They make their way into the little fractures and crevices in the foam.

Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It occurs slowly and on a Swim Spa Cover which is made of individual sections, at varying speeds. So eventually you’ll observe a couple of of the sections are truly getting heavy. The bar lifters on completions of the swim spa aren’t much help since you still need to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using numerous foam panels to build Swim Spa Covers that will ultimately end up in some land fill, they designed one that uses air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or break down at the joints either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the cover for it.
If you’re not all set to buy today, bookmark this site so you can find it once again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *