The Challenges to Swim Spa Covers

Swim Spas represent special challenges when it pertains to covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same reasons a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot harder.
Getting a new swim spa is an interesting occasion in life. You’re looking forward to the exercise you’ll get from using it. Perhaps you’re a little relieved to have actually lastly made a selection from the various designs you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Typically, the cover that gets home with your new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence because as soon as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are really small as they increase from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.

It occurs gradually and on a Swim Spa Cover which is made from specific sections, at varying speeds. So eventually you’ll discover one or two of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much help since you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com created a different style for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually end up in some garbage dump, they created one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to purchase today, bookmark this website so you can discover it again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *